Study on the Pulsed Flashover Characteristics of Solid-Solid Interface in Electrical Devices Poured by Epoxy Resin

LI Manping(李曼苹); WU Kai(吴锴); YANG Zhanping(杨战平); DING Man(丁曼); LIU Xin(刘鑫); CHENG Yonghong(成永红)

doi:10.1088/1009-0630/16/9/09

Plasma Science and Technology > 2014 > 16(9): 856-860. > DOI: 10.1088/1009-0630/16/9/09

LI Manping(李曼苹), WU Kai(吴锴), YANG Zhanping(杨战平), DING Man(丁曼), LIU Xin(刘鑫), CHENG Yonghong(成永红). Study on the Pulsed Flashover Characteristics of Solid-Solid Interface in Electrical Devices Poured by Epoxy Resin[J]. Plasma Science and Technology, 2014, 16(9): 856-860. DOI: 10.1088/1009-0630/16/9/09

Citation:

PDF (2014 KB)

Study on the Pulsed Flashover Characteristics of Solid-Solid Interface in Electrical Devices Poured by Epoxy Resin

1 State Key Laboratory of Electrical Insulation and Power Equipment, Xi’an Jiaotong University, Xi’an 710049, China 2 Institute of Electronic Engineering, China Academy of Engineering Physics, Mianyang 621900, China

Funds: supported by Coordination Foundation of Institute of Electronic Engineering, China Academy of Engineering Physics (No. WF2011- 013)

More Information

Received Date: July 08, 2013

Graphical Abstract

Abstract

Abstract

In electrical devices poured by epoxy resin, there are a lot of interfaces between epoxy resin and other solid dielectrics, i.e. solid-solid interfaces. Experiments were carried out to study the flashover characteristics of two typical solid-solid interfaces (epoxy-ceramic and epoxy- PMMA) under steep high-voltage impulse for different electrode systems (coaxial electrodes and finger electrodes) and different types of epoxy resin (neat epoxy resin, polyether modified epoxy resin and polyurethane modified epoxy resin). Results showed that, the flashover of solid-solid interface is similar to the breakdown of solid dielectric, and there are unrecoverable carbonated tracks after flashover. Under the same distance of electrodes, the electric stress of coaxial electrodes is lower than that of finger electrodes; and after the flashover, there are more severe breakdown and larger enhanced surface conductivity at interface for coaxial electrodes, as compared with the case of finger electrode. The dielectric properties are also discussed.
- epoxy resin,
- solid-solid interface,
- flashover characteristic,
- breakdown

FullText(HTML)

References (11)

References

1 StygarWA, Lott J A,Wagoner T C, et al. 2005, Phys.Rev. ST Accel. Beams, 8: 050401

2 Watson A. 1967, J. Appl. Phys., 38: 2019

3 Miller H C. 1993, IEEE Trans. Dielectr. Electr. Insul.,28: 512

4 Leopold J G, Leibovitz C, Navon I, et al. 2007, Phys.Rev. ST Accel. Beams, 10: 060401

5 Chen Y, Cheng Y H, Wu K, et al. 2008, IEEE Trans.Plasma Sci., 37: 195

6 Hawley R. 1968, Vacuum, 18: 383

7 Morales K P, Krile J T, Neuber A A. et al. 2006, IEEE Trans. Dielectr. Electr. Insul., 13: 803

8 Krile J T, Neuber A A, Krompholz H G. 2008, IEEE Trans. Plasma Sci., 36: 332

9 Teyssedre G, Laurent C. 2005, IEEE Trans. Dielectr.Electr. Insul., 12: 857

10 Fabiani D, Montanari G C, Cavallini A, et al. 2004,IEEE Trans. Dielectr. Electr. Insul., 11: 393

11 Wu K, Okamoto T, Suzuoki Y. 2007, IEEE Trans. Dielectr. Electr. Insul., 11: 461

[1]	Jung-Hwan IN, Youngmin MOON, Jang-Hee CHOI, Sungho JEONG. Consistency of intensity ratio between spectral lines with similar self-absorption characteristics during ungated laser induced breakdown spectroscopy measurements[J]. Plasma Science and Technology, 2019, 21(3): 34010-034010. DOI: 10.1088/2058-6272/aaed60
[2]	Teng FEI (费腾), Congyuan PAN (潘从元), Qiang ZENG (曾强), Qiuping WANG (王秋平), Xuewei DU (杜学维). Relative spectral response calibration using Ti plasma lines[J]. Plasma Science and Technology, 2018, 20(4): 45503-045503. DOI: 10.1088/2058-6272/aaaada
[3]	Shuxia ZHAO (赵书霞), Lei ZHANG (张雷), Jiajia HOU (侯佳佳), Yang ZHAO (赵洋), Wangbao YIN (尹王保), Weiguang MA (马维光), Lei DONG (董磊), Liantuan XIAO (肖连团), Suotang JIA (贾锁堂). Accurate quantitative CF-LIBS analysis of both major and minor elements in alloys via iterative correction of plasma temperature and spectral intensity[J]. Plasma Science and Technology, 2018, 20(3): 35502-035502. DOI: 10.1088/2058-6272/aa97ce
[4]	WANG Jinmei (王金梅), ZHENG Peichao (郑培超), LIU Hongdi (刘红弟), FANG Liang (方亮). Spectral Characteristics of Laser-Induced Graphite Plasma in Ambient Air[J]. Plasma Science and Technology, 2016, 18(11): 1123-1129. DOI: 10.1088/1009-0630/18/11/11
[5]	TANG Enling (唐恩凌), ZHANG Lijiao (张立佼), ZHANG Qingming (张庆明), SHI Xiaohan (施晓涵), WANG Meng (王猛), WANG Di (王迪), XIANG Shenghai (相升海), XIA Jin (夏瑾), HAN Yafei (韩雅菲), XU Mingyang (徐名扬), WU Jin (吴尽), ZHANG Shuang (张爽), YUAN Jianfei (袁健飞). Experimental Study on Light Flash Radiant Intensity Generated by Strong Shock 2A12 Aluminum Plate[J]. Plasma Science and Technology, 2015, 17(7): 529-533. DOI: 10.1088/1009-0630/17/7/01
[6]	WANG Songbai(王松柏), LEI Guangjiu(雷光玖), LIU Dongping(刘东平), YANG Size(杨思泽). Balmer H_α, H _β and H _γ Spectral Lines Intensities in High-Power RF Hydrogen Plasmas[J]. Plasma Science and Technology, 2014, 16(3): 219-222. DOI: 10.1088/1009-0630/16/3/08
[7]	ZHOU Hangyu(周航宇), CUI Zhengying(崔正英), MORITA Shigeru(森田繁), FU Bingzhong(傅炳忠), GOTO Motoshi(後藤基志), SUN Ping(孙平), FENG Beibin(冯北滨), CUI Xuewu(崔学武), LU Ping(卢平), YANG Qingwei(杨青巍), DUAN Xuru(段旭如). Spectral Analysis in EUV Range for Study of Core Impurity Behavior in HL-2A[J]. Plasma Science and Technology, 2014, 16(2): 89-92. DOI: 10.1088/1009-0630/16/2/01
[8]	HAO Xiping (郝希平), SONG Zhiqiang (宋志), HE Jian (贺健), LI Qiuze (李秋泽), et al.. Calculation of the Effect of Opacity on the Solar Spectral Lines of CIV[J]. Plasma Science and Technology, 2013, 15(8): 760-763. DOI: 10.1088/1009-0630/15/8/08
[9]	GUO Jun(郭俊). The Effects of Relative Drift Velocities Between Proton and He2+ on the Magnetic Spectral Signatures in the Plasma Depletion Layer[J]. Plasma Science and Technology, 2011, 13(5): 557-560.
[10]	LI Jiquan, Y. KISHIMOTO. Wave-Number Spectral Characteristics of Drift Wave Micro-Turbulence with Large-Scale Structures[J]. Plasma Science and Technology, 2011, 13(3): 297-301.